Return to site

Top Benefits of Waterjet Cutting

broken image

Whether you are new to the technology or are a veteran in it, you need to be well aware of the benefits, as many as they are, of using waterjet cutting. Read on in this post and see some of the benefits of waterjet cutting as a technology so as to enable you as a business person to make such an informed business decision going forward.

Talking of waterjet cutting, one thing that should be well understood is that there are two kinds of waterjet cutting techniques and these are the pure waterjet cutting and the abrasive waterjet cutting. For the pure waterjet cutting technique, this is that which basically sees the use of nothing but the water streams for the cutting and is most commonly applied for the cutting of the soft materials such as foam and paper. Looking at abrasive cutting, this that which involves the addition of an abrasive to the water stream for the cutting. These granular abrasive serve to accelerate the power and speed of the cutting which enables them to cut some of the hard materials like metal and ceramics with a lot of ease.

Check out the following for some of the benefits that come with the water jet table cutting techniques and improve your general knowhow of the technology so as to be able to make better business decisions.

First and foremost, Flow waterjet cutting is applicable on a wide range of materials, be it on the composites, metals, plastics, glass, rubber, stone or rock, and ceramics too. With the addition of the granular abrasives, there will be in fact added greater efficiency and effectiveness of the cutting method as you will even be able to cut materials as thick as 200mm.

The other worthy benefit of the waterjet cutting technique is in the fact that it results in such cuts that have no heat affected areas. This is seen as a result of the fact that this is one of the cutting technologies that actually uses the cold cutting technologies which not only ensures such clean cuts but as well helps improve the safety of the operators looking at the fact that there is so reduced such odds of suffering burns when going about the cutting. Besides this, cold cutting as well happens to be a great alternative when you look at the fact that it helps bypass the heat which eliminates the risk of material distortion and as such an ideal method for the cutting of such materials as metals and the like. With waterjet cuts, you end up with such smooth and burr-free cuts. For more ideas about machines, go to https://en.wikipedia.org/wiki/Heavy_equipment.